Schluter Systems LIPROTEC LT EBR 1 Mode D'emploi page 25

use a Bluetooth-enabled smartphone, tablet or similar device
as a transmitter. These different devices will hence be
referred to as "mobile devices".
The Schlüter app must be installed onto the mobile device.
Instructions on how to install the app can be found along with
the QR code on the back side of this manual.
If your device cannot recognise any QR codes, you can
alternatively search for it in your app store.
Install the Schlüter app, as described in the operating

instructions for your mobile device.
To control the Bluetooth receiver with a mobile device, you
must first establish a Bluetooth connection between both
devices. To do this, proceed as follows:
Press the "On/Off" button for 3 seconds and the "Up"

arrow button (see Fig. C, Pos 2 and 3) on the remote
control.
After a delay of 2 seconds, the Bluetooth receiver

will now display the status "waiting on a connection"
for 90 seconds by indicating a quick flashing of the
LED on the bluetooth receiver (see fig. A, pos 6) in
the colours blue and yellow.
On the mobile device's display, "LED-xxx" will be

displayed. "xxx" is the Bluetooth receiver's device
number. If you use several Bluetooth receivers,
each Bluetooth receiver will be displayed as
separate entries.
Bluetooth receiver operating instructions
EN
Operation
23