Hkoenig STC56 Manuel D'utilisation page 7

ASSEMBLY BEFORE USE
Fig.1 shows the connection of the hose and the vacuum cleaner:
Put the hose connector in front of the vacuum cleaner .Then insert it into the inlet hole and
turn right. If you want to disassemble it, you can turn the hose connection left and then pull it
out.
Fig.2 shows the connection of the hose and the extending metal tube:
Hold the flexural connector of the hose and put it into the bigger hole of the tube.
Fig.3 shows the connection of the tube and the brush tool:
Put the metal tube into the hole of the brush and rotate it to fasten them.
Fig.4 shows how to check the winding of the power cord.
You can pull the power cord out of the machine and stop it when you see the yellow mark.
Make sure the red mark is not out. When your sweep is over, first turn off the power, pull the
plug out of the socket, and then push the winding device button until the cord is completely in
the machine.
Fig.5 shows the power button
Put the plug into the socket, push the power button to control the work of the machine.
Fig.5
HOW TO USE
Fig.1
Fig.3
Fig.2
Fig.4