Sony BKM-FW32 Mode D'emploi page 21

When the option slot is located on
the left side of a Display unit*
* The location of the option slot differs
depending on the model of the Display
unit. If your Display unit has more than
one option slot, install the device in a
COM port, a slot used for the network.
Refer to the Operating Instructions for the
FWD series as well.
2
Check the direction (top/bottom) of
this device and insert it into the flat
panel display. Make sure that the
connector inside the Display is firmly
connected.
Using a slot screwdriver, tighten the
two screws of this device. Connect the
LAN cable, as needed.
2
2
Caution
Do not touch the connector inside the
Display. Doing so may result in injury to
yourself or cause this device to
malfunction.
Preparations for Using the Networking Function
7
GB