AEG JP 10 Mode D'emploi D'origine page 35

Problem
Low output voltage.
TV operation and / or Audio sys-
tems and / or external appliances
• Snow image
• image not steady
• humming, booming and whir-
ring sound audible
The On/Off switch (15) is on but
the compressor does not start
inflating.
The device does not automati-
cally stop inflating at the preset.
The device is pumping air but the
tyre/item is not inflating.
The pressure in the tyre is less
than the set pressure.
The battery pack will not be
charged.
Possible cause
Input voltage too low - Low
voltage-protection.
Polarity, incorrect connections,
short-circuit protection.
Rated power above max. Rated
power - overload protection.
TV interference.
Battery pack drained.
Pressure setting incorrect.
Valve adapters not connected
properly.
Tyre/item leaking.
Tyre too hot.
Tyre volume too great.
The fuse has blown.
English
Solution
Immediately switch off the voltage converter.
Check the connections and charge the battery
pack.
Switch off the power inverter immediately.
Disconnect all external appliances. Check all
connections, cables and external appliances.
Adjust where necessary.
Reduce the total power of connected devices to
the max. power rating.
Place power inverter as far away from TV set
as possible.
Check aerial connection and setting. Place
aerial cable away from power inverter. use a
shielded aerial cable.
Verify the battery pack is charged
Verify the correct values were preset.
Ensure the chuck (23) is properly connected to
the valve of the tyre/item.
Check if the tyre/product is leaking air.
The tyre pressure increases as the temperature
rises. The recommended tyre pressure is typi-
cally specified for cold tyres (approx. 20 °C). Do
not check the tyre pressure on warm tyres (e.g.
after long trips). Please refer to the owner's
manual for your vehicle.
With large tyres such as on campers it's advisa-
ble to increase the pressure by 2 PSI (0.1 bar) to
compensate for the high volume.
Replace the fuse (see chapter „Replacing
fuses").
35