Special Safety Regulations - Arktic 237588 Mode D'emploi

• This appliance should not be operated by persons with reduced physical, sensory or mental
capabilities, or persons that have a lack of experience and knowledge.
• This appliance should, under any circumstances, not be used by children.
• Keep the appliance and its power cord out of reach of children.
• WARNING: ALWAYS switch off the appliance and unplug from power socket before
cleaning, maintenance or storage.

Special Safety Regulations

• Use the appliance only as described in this manual.
•
addition to the noise of the compressor, you might be able to hear the coolant flowing
around the system. This is unavoidable and does not have any adverse effect on the
performance of the appliance. Care must be taken during transportation and setting up
of the appliance that no parts of the cooling system are damaged. Leakage coolant can
damage the eyes.
• The foam blowing agent used is Cyclopentane in this appliance. It is highly flammable.
• This appliance is suitable for an ambient temperature from 16°C ~ 38°C.
• Do not place the appliance on a heating object (gasoline, electric, charcoal cooker, etc.)
EN
Keep the appliance away from any hot surfaces and open flames. Always operate and
place the appliance on a horizontal, stable, clean, heat-resistant and dry surface.
• Do not use the appliance near explosive or flammable materials, credit cards, magnetic
discs or radios.
• This appliance is not intended to be operated by means of an external timer or separate
remote-control system.
• WARNING: Keep all ventilation openings in the appliance enclosure clear of obstruction.
• WARNING: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
• WARNING: Do not damage the refrigerant circuit.
• Allow at least 10 cm spacing around the appliance for ventilation purpose during use.
• Do not use a water jet, flush directly with water or steam cleaner as the parts will get wet
and electric shock might be resulted.
• CAUTION! Securely route the power cord if necessary in order to prevent unintentional
pulling or contact with the heating surface.
• Do not clean or store the appliance unless it is completely cooled down.
• The appliance should not be tipped over an angle of 5°. After installing the appliance, wait
for 2 hours before connecting it to the electrical power supply to switch on. The same
applies if the appliance is moved at a later date.
4
CAUTION! Risk of fire! The refrigerant used is R600a. It is a flammable
natural gas which is environmentally friendly. It does not damage the ozone
layer and does not increase the greenhouse effect. The use of this coolant
has, however, led to a slight increase in the noise level of the appliance. In