Other Settings - König Electronic CMP-NWIPCAM22 Mode D'emploi

Other Settings

WIFI Setting
Enter the Wireless LAN Setting as shown in Figure 10 below, click the "Search" button several times and it will
show you the wireless networks detected in the Wireless Network List column. Select one of them and tick
"Using Wireless Lan", then the relevant data of the selected wireless network will be shown in the succeeding
blanks. Enter the password and click "Set", then the WIFI setting is finished.
Note: When the device is connected to both WIFI and wired, after it starts up, it will connect first to the wired
network, if it can't connect, then it will connect to the WIFI. The IP address and port are the same for either
wireless or wired network.
Advanced User Settings
There are three levels of authority; they are Administrator/Operator/Visitor. The Administrator has the highest
authority, it can make any change to the settings. The Operator account can only operate the IP camera, it
cannot make changes to the settings, please refer to Figure 11. The Visitor account can only watch the video,
it cannot operate the IP camera.
123456.
Other settings
You can choose open or closed indicator LED. If the PTZ centre is set to "Yes" on startup, when the device is
started up, Pan/Tilt will move to the centre and then stop. You can also set the horizontal patrol rounds and
vertical patrol rounds, when you click patrol on the "view" interface, it will round according to your rounds
setup. You can also set the PTZ rate, 0 means fastest.
Figure 10
Figure 11
By default, the administrator's user name is admin, password is
7