Installation And Electrical Connection - Aspira AP0904 Manuel D'utilisation Et D'installation

INSTAllATION ANd ElEcTRIcAl cONNEcTION

1. disconnect the power supply circuit
2. Release the cover of the motor support
3. disconnect the motor connections from the terminal block to remove it fig. 1
4. Place the board and seal as indicated in fig. 2
5. connect the motor to terminal block A and perform the electrical connections as in diagram fig. 6
FOR ASPIRTIMER N (AP0904)
• Attach a protective casing, tighten the casing fixing screw and close the adjusting hole of the Timer with cap joint to
the seal fig. 3.
FOR ASPIRHYGRO TIMER (AP0906)
• connect both boards attaching the connector of the Hygro board to the Timer board fig. 4.
• Attach both protective casings, tighten the casing fixing screws and close the adjusting hole of the Timer with cap
joint to the seal fig. 5.
OPERATION OF ASPIRTIMER N (AP0904)
ATTENTION:
The timer activates the extractor when the light is turned on. When the light is turned off, the extractor continues
to work for a programmable period of 45 seconds to 20 minutes approximately.
The timer is provided with a minimum setting of 45 seconds.
To change the operation time, proceed as follows:
• Interrupt the power supply circuit.
• use a screwdriver on the trimmer located under the cap (B - fig. 3), in the desired direction.
• Verify that the operation time is the correct one.
OPERATION OF ASPIRHYGRO TIMER (AP0906)
The extractor starts working when the level of relative humidity RH present in the room, exceeds the pre-set activation
point and continues to work until the RH value falls within the pre-set threshold. When this threshold is reached the
TIMER function allows the extractor to continue to work for a programmable period of time of approximately 45 seconds
to 20 minutes so as to further reduce the value of relative humidity in the room. The value of relative humidity RH can be
regulated from a minimum value of 40% RH to a maximum value of 80% RH.
This extractor can be used manually also in the TIMER setting (for electric connections see fig. 6).
To change the humidity level, proceed as follows:
• Interrupt the power supply circuit.
• use a screwdriver on the trimmer (c - fig. 5), in the desired direction.
Please note: Remove the closing cap on the Hydro board seal.
The adjusting hole of the board MuST be open.
dISPOSAl
WARNING:
Important information concerning the environment friendly disposal of the appliance
This product conforms to Eu directive 2002/96/Ec. The symbol of the barred waste bin indicates that, at the end of its useful
life, the product has to be collected separately from the domestic waste.
The user will have to take the product to a collection centre for waste electrical and electronic equipment, or return it to a
retailer on purchase of a replacement. Failure to do so may incur the penalties established by laws governing waste disposal.
Proper differential collection and the subsequent recycling, processing and environmentally compatible disposal of waste
equipments avoids unnecessary damage to the environment and possible related health risk and promotes also recycling of
the materials used in the appliance.
4
E N G l I S H