Description Of Device; Setting The Time - Beurer GS 23 Photo Mode D'emploi

– Please dispose of the appliance in accordance with the Directive 2002/96/EC on Waste Electri-
cal and Electronic Equipment (WEEE). In case of queries, please contact the municipal authori-
ties responsible for waste disposal in your area.

3. Description of Device

1. Display with clock function
2. Scale with picture frame
3. key (= UP)
4. SET key
5. key (= AB)
6. Wall mount
7. Flap
8. Base
9. Battery compartment
4. Use
This scale is used to determine the weight of human beings. The scale has a weighing range up to
330 lbs (150 kg).
It also has an integrated clock and can also be used as a photo frame. This gives you a variety of
individual setup options.
4.1 Batteries
If present, pull the battery insulating strip off the battery compartment cover or remove
the battery's protective film and insert the battery according to the polarity. If the scale
fails to operate, remove the battery completely and insert it again. Your scale is equip-
ped with a "replace battery" indicator. When the scale is operated with a battery which
is too weak, "Lo" appears in the display field and the scale automatically switches off.
The battery must be replaced in this case (2 x 3 V lithium battery CR2032). The used,
completely drained standard and rechargeable batteries must be disposed of in
specially marked collection containers, at toxic waste collection points or electrical
product retailers. You are legally obligated to dispose of the batteries.
note: Batteries containing pollutants are marked with the following symbols:
Pb = Battery contains lead, Cd = Battery contains cadmium, Hg = Battery contains
mercury.

4.2 Setting the time

After removal of the battery isolation strip, the display shows „0:00" with a flashing hour indicator.
Set the hours with the „UP and DOWN" keys and press „SET" to confirm. Then the minutes start
flashing. Set the minutes with the „UP and DOWN" keys. Press „SET" to confirm and to exit the time
setting procedure.
If a key is not pressed within 30 seconds of removal of the battery isolation strip, „0:00" is automati-
cally set as the time.
note: The time is displayed in 24-hour format.
1
2
5
3
SET
4
6
6
7
9
8