Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTE:
Place the detent (6) so it will slide over the slot (5) in
the guard mount
• When the guard clamp is fully onto the guard mount, rotate the
guard 180° so it is positioned at the top of the tool.
• Press the guard locking lever firmly inward toward the tool to
lock the guard (3) on to the tool.
INSTALLING THE CUT-OFF DISC (FIG 3)
WArNING:
cut-off disc is rated for at least 24,000 rPM and is
in good condition.
1. unplug the tool.
2. Place the arbor wrench (1) on the flat part of the spindle.
3. While holding the arbor wrench, using Hex key (2) provided,
remove the disc locking screw (3) by turning it counterclockwise.
4. Remove the outer flange washer (4).
5. Slide the cut-off disc (5) over the spindle shoulder and rest it flat
against the inner flange (6).
6. Reinstall and tighten the outer flange washer and the disc
locking scew.
WArNING:
is firmly tightened, hold the tool so the guard is
between you and the cut-off disc and turn the tool
ON. If the cut-off disc wobbles or the tool vibrates,
turn the tool OFF immediately and investigate and
correct the cause.
OPErATION
STARTING AND STOPPING THE TOOL (FIG 4)
WArNING:
switched off. Accidently starting the saw could cause personal injury.
The tool has a combination Lock-Off and ON/Off switch to prevent
from unintentional starting of the tool.
To start the tool
1. Press downward on the rear part of the switch (1) with your
thumb.
2. While pressing the rear part of the switch, slide the switch
forward to start the tool. See figure 4.
NOTE:
The ON/Off switch will click into the Lock-On position
when pushed fully forward. The tool will continue to operate until
the switch is turned off.
NOTE:
Always let the disc reach full speed before guiding the
tool into the workpiece.
WArNING:
reaching full speed could cause your tool to KICKBACK towards you, resulting in
serious personal injury.
To stop the tool,
3" Electric Cut-off Tool
Operator's Manual
Make sure the replacement
Once the disc locking screw
Before plugging in the tool, always check to see that the tool is
The cut-off disc coming into contact with the workpiece before
press downward on the rear part of the switch. Allow the disc to come to a complete stop.
2
4
6
3
4
2
3
5
6
FIG 4
GCOT335
5
1
FIG 2
1
FIG 3
1
Publicité
Table des Matières
