Installation - B.A. International Ultimate BASE280 Manuel D'utilisation

Please carefully follow the instructions below to ensure proper function of
the device.
Fiber-Optic Probe Installation / Replacement
1. Insert the fiber-optic probe into the handpiece until the base of the probe
is completely matched to the handpiece and listen for a "click" that signifies
the probe has been securely fastened.
2. Place the protection shield on the front end of the handpiece, and the orange
anti-glare cone or tube onto the tip of the fiber-optic probe and adjust its
position according to the dentist's preference.
3. To remove, simply pull the fiber-optic probe outwards to remove it from the
handpiece.
IMPORTANT :
Don't use excessive force when installing the above parts to avoid
possible breakage or damage.
Battery Installation / Replacement
IMPORTANT :
After battery replacement, all user settings will revert back to the factory
settings.
IMPORTANT :
Prior to using a new battery, please charge for a minimum of 4 hours to
ensure maximum battery life.
WARNING :
There is a danger of explosion if the battery is incorrectly replaced.
Trained service personnel should replace only with the same or
equivalent battery type as recommended by the manufacturer.

Installation:

7