Preparations - Kenwood KDC-X895 Guide De Démarrage Rapide

Preparations

Release
[DISP]
Exit Demonstration Mode
Turn off the demonstration mode
when you use it for the first time after
installation.

Press the Control knob to quit the
demonstration mode when the
messages "To Cancel DEMO Press the
volume knob" are displayed (approx. 15
seconds).

Turn the Control knob and press it
when the "YES" is displayed.
The demonstration mode can also be
canceled in the Function setting mode.
Refer to <Demonstration mode Setting>
(page 34) of Instruction manual
Adjusting the Clock

Press the [DISP] button several times to
display the clock.

Press the [DISP] button for at least 1
second.

Turn the Control knob to adjust the
hour, and then press the Control knob.

Turn the Control knob to adjust the
minute, and then press the Control
knob.
4 | Quick Start Guide
Control knob (Volume knob)
Detaching/ Reattaching the
Faceplate
¤
• Remove the faceplate at once after
pressing the Release button; otherwise it
can fall down due to vibration.
• The faceplate is a precision piece of
equipment and can be damaged by
shocks or jolts.
• Keep the faceplate in its faceplate case
while detached.
• Do not place the faceplate (and the
faceplate case) in areas exposed to direct
sunlight, excessive heat or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
Press the Release
button.