Kruger SECOMAT 75 Mode D'emploi page 67

Faults
Before contacting the fault service team, please consult the following questions:
If the device is not running
Is the mains plug correctly plugged in?
Is the electric box's fuse OK ?
Is the mains cable OK ?
If the device is running constantly
Are the doors and windows closed?
Can humidity be originating from other sources?
Has the correct drying programme been selected (see page 64: Choosing the
appropriate drying programme)
If the device is providing unsatisfactory dehumidification
Is the air circulating in the room?
Are the intake and exhaust openings unobstructed?
Is the room temperature too high or too low (see page 62)?
Is the filter clean?
Is there at least 0.5 metre between the outlet opening and the first piece of washing?
Are only a few or single items of washing hanging up? (see page 65: Manual mode)
Blinken der roten LED
If the red fault lamp is flashing, the device is interlocked. Each fault has its own flash code.
In other words, depending on the type of error, the lamp will flash at a different frequency.
Establish the fault code and take a note of it before pressing the reset button (see page 59,
no. 6) behind the filter. If the interlock cannot be reset despite several attempts, please
contact the fault service team. Tell them the error code as well as the article no. and serial
no. that can be found on the identification plate on the front left-hand side of the device.
This will help to considerably improve troubleshooting.
67