Installation; Before You Begin - Siemens HE2224 Instructions D'installation

Installation

Before You Begin

Tools and Parts Needed
Additional Parts Needed For Hard
Wire Installations
Parts Included
Cabinet Requirements
Required Clearances
• 50 Amp Power Supply Cord Kit (not necessary for Canadian installations)
• Measuring Tape
• Phillips Head Screwdriver
• 1-1/4" (31.8 mm) Wrench
• Pencil
• T-20 Torx Screwdriver
• Screws (2) and Anchors (2) for Anti-Tip Bracket (style will vary depending on
mounting surface)
• Level
• Drill and Drill Bit
• Safety Gloves and Goggles
• Tape (optional)
• Cloth or Cardboard (optional - to protect floor)
• Flexible Conduit (for Hard Wire Installation Only)
• Torque Wrench (for Hard Wire Installation Only)
•Note:
Power Supply Cord Kit not necessary for Hard Wire Installations
• Anti-Tip Bracket
• Terminal Lugs (for use with Hard Wire Installations) (not necessary for Cana-
dian installations)
This unit is designed for installation near adjacent walls and projecting surfaces
constructed of combustible materials. Allow a minimum of 30 inches (76.2 cm)
between cabinets where range is to be installed (0.47" (12 mm) clearance from
range sidewall to cabinet required in Canada).
These clearance instructions were determined using Standard American cabinets.
Standard base cabinets measure 36 inch (91.4 cm) high x 24 inch (60.9 cm) deep.
Cabinets over the cooking surface and cabinets adjacent to those over the cook-
30" (76.2 cm) Minimum
between cabinets
Figure 1: Cabinet Clearances
English 3