Camille Bauer KINAX WT 710 Mode D'emploi page 23

Drilling and cut-out diagram
for fi xing with
cheesehead screws
Drilling and cut-out
diagram for
fi xing with clamps
Fixing with
mounting foot
Basic unit for fi tting to
measuring instruments
with revolving indicator
shaft
Drilling and cut-out
diagram for measuring
instrument housing
Accessory kit for
pressure gauge mounting
5
M3
50
37
(If the cable glands are in the way when mounted as above, the KINAX WT 710 should be
rotated over 120°, after loosening the 3 screws holding the gear).
67
83.1
The measuring instrument must have an extended indicator shaft at the back (1.5 mm
diam., length 6...7 mm).
3.2
M4
Ø6.8
±0.2
80
95
44-H8
25
M4
53 ±0.05
23