Troubleshooting - SilverCrest SLR 30 A1 Mode D'emploi Et Consignes De Sécurité

Troubleshooting

The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service).
Fault
The appliance will
not switch on/does
not react.
The colour of the il-
w
luminated ring
does not change.
The filter change
3
button is
flashing even
though the filter
has already been
changed.
SLR 30 A1
Cause
The appliance is not
switched on.
The mains plug is not
plugged in.
The socket is not
supplying any power.
The appliance is
defective.
The particle sensor is
dirty.
The filter timer has not
been reset.
Remedy
Make sure that the appliance is properly
connected to the power supply.
Press the On/Off button
on the appliance.
Insert the plug into a mains power socket.
Check the house mains fuse.
Switch off the appliance and pull out the
mains plug.
Contact Customer Service (see section
Service).
Clean the particle sensor (see section
Cleaning the particle sensor).
Press the filter change button
about 3 seconds to reset the filter timer
(see section Changing the filter).
4
to switch
3
for
GB │ IE │
15 ■