Key Character Assignment; Key Assignment; Entry Of Text - FMC Technologies Sening MultiFlow Manuel D'utilisation

MN F09 012 US  DOK-392E  Issue/Rev. 2.01 (01/13)
1.3.1

Key assignment


Apart from the entry of numbers, the keys can also be used for the entry of letters or special
characters. All the characters used can be printed out. The letters and special characters
assigned to the keys are listed in the table in chapter 1.3 "Key character assignment" / page 4.
1.3.1.1

Entry of text


To enter text, locate the required character below the number.

Press this key briefly and repeatedly until the required character appears in the text field.

If you discontinue pressing the key for a longer time, the character shown in the display is
accepted and the cursor moves automatically one step further waiting for the next character to
be entered.

You can use function key <F2> to delete the last letter entered.
®
Sening is a registered trademark of FMC Technologies
Function key <F2>, assignment depends on program,
defined via SW
Function key <F3>, assignment depends on program,
defined via SW
Character group # °
Special characters Ö; Ä; Ü; ä; ö; ü; ß;
The special characters depend on the selected language.
Character group : , ; / ! ? = . ( )
Start of discharge, acceptance of packed products on the
invoice or the delivery receipt
Stops discharge, goes back one menu point
Triggers printout, confirmation of entered values for some
entries; see "Reports", page 11
Acceptance of entered values, confirmation of values
MultiFlow  General
$ £ % &
- +
5