Disposal; Disposal Of Production Materials And Auxiliary Materials; Disposal Of A Functional Component Or System; Proper Intended Use - FMC Technologies Sening MultiFlow Manuel D'utilisation

MN F09 012 US  DOK-392E  Issue/Rev. 2.01 (01/13)
Pos : 8.8 /T ec hDOC /Seni ng/Sic herheit/| 3--->>> Ents orgung @ 1\mod_1323246457101_19.doc x @ 30406 @ 3 @ 1
1.1.4

Disposal

Pos : 8.9 /T ec hDOC /Seni ng/Sic herheit/S4: Entsorgung @ 0\mod_1309780651030_19.doc x @ 8643 @ 44 @ 1
It is the operator's responsibility to obtain the necessary information about all relevant
regulations and requirements from your local authorities. Ensure that the relevant materials are
disposed of in an environmentally safe fashion.
§
The operator is responsible for ensuring compliance with all general and local regulations which
are in force at the time of disposal.
1.1.4.1

Disposal of production materials and auxiliary materials

• Mineral oil products are extremely hazardous to the environment; they must not be allowed to
enter the drains/sewage system or the ground.
• These materials and any objects contaminated with them should be disposed of via suitable
waste disposal facilities.
Disposal of batteries
The batteries in the controller should be replaced by a skilled person.
Used batteries must not be disposed of as standard domestic waste.
Ensure that all used batteries are disposed of via suitable disposal
facilities.
1.1.4.2

Disposal of a functional component or system

• When a functional component or system is taken out of service, we recommend that it should
be sorted into its different types of waste and then disposed of or recycled as appropriate. Sort
and separate iron, nonferrous metals, plastics, electronic waste, etc.
• Fuels, grease, oil and objects or lines contaminated with them must be disposed of separately.
Pos : 8.10 /T echD OC/Seni ng/Sic her hei t/| 3--->>> Bes timmungsgemäß e Ver wendung @ 1\mod_1323251107348_19.doc x @ 30458 @ 3 @ 1
1.1.5

Proper intended use

Pos : 8.11 /T echD OC/Seni ng/Sic her hei t/S5: Besti mmungsgemäß e Ver wendung (M essanl agen) @ 0\mod_1297949433054_19.doc x @ 1336 @ @ 1

The measuring systems are to be used exclusively for delivery of low-viscosity mineral oils on
tank trucks. The corresponding applicable safety regulations (e.g. Ex protection) must be
complied with.

Any form of use which exceeds the scope described above is deemed to be improper use; the
manufacturer is not liable for damages resulting from such improper use.

Proper use also includes compliance with the conditions set out by the manufacturer with regard
to operation, installation and maintenance.

The measuring systems must only be operated, serviced and repaired by personnel who are
familiar with the equipment and who have been trained regarding the dangers involved.

The manufacturer cannot be held liable for any damages arising as a result of unauthorized
changes to the measuring systems.
®
Sening is a registered trademark of FMC Technologies
MultiFlow  General
3