Pour The Sample Into The Measurement - DRAMINSKI GMDM Mode D'emploi

Place the instrument on the horizontal and
stable basis, e.g. a table.
Befor starting the measurement check if:
a) the measurement compartment is empty
b) and put the empty dosage tube on the
instrument to tare it.
OK
1. Press button - then the following commands
TARE
will appear:
Rye
please wait
Rye
taring 1,2 (1,2,3)
10
After taring (which take some seconds) the following
commands will appear:
Rye
pour in sample

Pour the sample into the measurement

compartment by using the special dosage tube.
2. Filling the dosage tube.
After taring take the dosage tube off the
instrument and fill it with grain. Remove excess of
grain by turning a metal propeller. Put the dosage
tube carefully on the instrument.
The test sample should be properly collected and
cleaned. Careful measurement of the amount
of grain in the dosage tube will contribute to
obtaining the right results.