Important - TFA Dostmann HiTRAx PULSE TFA 42.2005 Mode D'emploi

TFA No. 42.2005 Anleitung_02_16
HiTRAX PULSE –
3D Pedometer with clock
9. ON/OFF button
• IMPORTANT: In order to increase battery life, please
turn off the instrument when not in use. Press and
hold button until the display is completely off.
• The basic setting and the memory are retained.
• Press button again and the instrument turns on.
10. Power-saving mode
• When the instrument is not used (approx. 10 minutes)
the power saving mode will be activated.
• Only the time appears on the display.
• To deactivate the power saving mode move the instru-
ment softly and time and STEP appear again on the dis-
play.
11. RESET function
• Use a pin to press the RESET button at the backside
and reset the instrument.
• °C appears on the display.
• All settings are deleted and the basic setting must be
repeated.
12. Attachment
• Because of the 3D sensor, the pedometer can be worn
everywhere (belt, in the bag or around the neck....).
18
23.02.2016 17:41 Uhr
HiTRAX PULSE –
• On belt: Attach the pedometer with the clip on your
waistband or belt.
• Around the neck: Pull a cord through the eyelet on the
device and then knot them together.
13. Battery replacement
• Change the battery when the battery symbol
appears on the display.
• Observe correct polarity, + pole above.
14. For your safety
• The product should only be used as described within
this instruction.
• Unauthorised repairs, modifications or changes to the
product are prohibited.
• Keep this instrument and the battery out of reach of
children.
• Batteries must not be thrown into a fire, short-circuited,
taken apart or recharged. Risk of explosion!
• Batteries can be fatal if swallowed. If a battery has been
swallowed, get medical assistance immediately.
Seite 10
3D Pedometer with clock
Caution!
Risk of injury:
19