CALOR 6346 Mode D'emploi page 16

a) Model 6346 (fig. 4).
Tu rn dial B to position .
The appliance then generates 1000 or 2000 W, according to the position of the towel-drier bar,
« d rying» or «heating».
It is then regulated according to the position of the thermostat dial A.
Your appliance will operate until you turn dial B back to position 0 : Off .
b) Model 6348 (fig. 5).
Tu rn dial B to position .
The appliance then generates 1000 or 2000 W, according to the position of the towel-drier bar,
« d rying» or «heating» and will be regulated according to the position of the thermostat dial A.
Your appliance will operate until you turn dial B back to position 0 : Off .
- If you turn dial B to position
tion of the towel-drier bar and will still be regulated by the therm o s t a t .
- After 2 hours, the appliance cuts out.
To turn it on again, t u rn the dial to position
d rying cycle.
c) Model 6349 (fig. 6).
Your appliance can be turned on manually or by pro g r a m m i n g .
In both cases, your appliance will generate 1000 or 2000 W, according to the position of the
towel-drier bar, «drying» or «heating», and will be regulated according to the position of the ther-
mostat dial A.
Tu rning on the appliance manually.
Tu rn dial B to position .
Your appliance will operate until you turn dial B back to position 0 : Off .
P rogramming the appliance.
Tu rn dial B to position
With the pro g r a m m e r, you can programme the operating and stop times in intervals of at least
30 min. over a 24 hour period.
- You must first set the time on the appliance's clock, by turning the programming dial to the
r i g h t , in order to position the figure re p resenting the time against the mark on the housing (fig. 7
and 8). Then pull the studs o u t w a rd s to define the re q u i red operating periods.
For example : if you wish to programme your appliance to heat your bathroom from 6 a.m. to
8 a.m., pull out the 4 studs located between graduations 6 and 8 (fig. 8).
A c c o rd i n g l y, your appliance will start up every day from 6 a.m. to 8 a.m. and will be re g u l a t e d
a c c o rding to the thermostat position.
Nota : you can s t o p your appliance m a n u a l l y during programmed operation by positioning dial
B on 0 or operate it outside the programmed operating times by positioning dial B on manual
operation position , without modifying your daily pro g r a m m i n g .
7. ADJUSTING THE THERMOSTAT
Your appliance is equipped with an ambient thermostat A which maintains the chosen tem-
p e r a t u re at a constant level in the room you wish to heat. The maximum position enables
c o n t inuous operation of the appliance in normal conditions of use. The intermediate positions
c o rrespond to the diff e rent temperature settings and automatically stop and re s t a rt the appliance.
, the appliance will operate for 2 hours, irrespective of the posi-
(fig. 6).
then back to position if you wish to re s t a rt a