Correct Use; Safety Instructions - AgroLogic MilKPot 50 Mode D'emploi

Operating instructions
EN
1. General
These operating instructions comprise instructions for use and safety information. Please read the instructions carefully and note the regulations
and relevant information before putting the device into operation. Please keep these operating instructions in a safe place for later use!

2. Correct use

This milk heater is intended for warming milk and feed prepared using water. Any other use, especially the warming of food, is deemed incorrect.
In the event of incorrect use or modifications to the device, the manufacturer's warranty and liabilities shall be deemed invalid.

3. Safety instructions

CAUTION!
Hot surfaces and defective connection cables.
Risk of burns, electrical shock, fires and short circuits.
• Do not place device on objects or surfaces that are sensitive to heat.
• The surface of the tank will still be hot when the device is switched off!
• Do not touch the tank or place it on heat-sensitive surfaces.
• Do not allow electrical supply cables to come into contact with hot surfaces, heat, oil or sharp edges.
• Do not pull on the electrical supply cable to unplug or transport the device.
Risk of physical injury and material damage if used incorrectly!
• Check the temperature of the heated liquid with a thermometer before feeding.
• Ensure that the device is only used by people who have the professional skills required to do so.
• Ensure that the voltage specified on the type plate matches the voltage of your power source.
• The device may only be connected to mains sockets which are isolated separately via a circuit breaker (FI).
• Do not use any multiple sockets. This is a very powerful high performance device.
• Before each use, check that the device and the power cable in particular are in good condition. Do not operate the device
if a component is defective.
• Never operate the device without supervision.
• Always keep the device in a safe, dry place out of the reach of children.
• Never remove the device type plate or film on the control unit.
• National and international safety, health and occupational safety regulations must be observed and complied with.
• When the device is switched on, the liquid to be heated must not be touched.
• Disconnect the device from the power supply before cleaning, relocating or servicing it.
• Do not block off the upper overflow! This opening is designed to compensate air movement during the heating process! Closing it off
can cause the tank to burst or implode!
• Only use the device in closed spaces.
• Do not splash cold water onto the tank! This can damage the device! The steam can lead to scalds.
4. Setup of the device
The device comprises the following components:
1) Cover with handle
2) Air compensation opening for water bath
3) Filling nozzle with valve for water bath
4) Control unit for heating element
5) Mains connection cable
6) Outlet valve
7) Water bath viewing window
8) Tank
9) Check light
10) Control dial
11) Main switch
9
11
10
8
1
8
4
6
2
7
3
5