Cleaning & Maintenance; Maintenance And Repair; Technical Data; Accessories And Spare Parts - AgroLogic MilKPot 50 Mode D'emploi

6. Cleaning / maintenance
CAUTION!
Risk of physical injury and material damage if used incorrectly!
• Disconnect the mains plug and let the tank cool down before commencing any cleaning work.
• Under no circumstances must you use a high-pressure cleaner or any other type of direct water jet! This can damage the device!
• Do not splash cold water onto the tank! This can damage the device! The steam can lead to scalds.
The milk warmer must be cleaned after every use. The tank can be cleaned using a soft sponge cloth (do not use scrubbing brushes, wire brushes,
wire wool or other abrasive cleaning tools) and lukewarm, soapy water. To clean the control unit, cover and connecting cable, use a soft, damp
cloth that must be completely free of solvents (acetone, petrol, alcohol or similar). Do not use any aggressive cleaning agents! Take particular care
when flushing the tank's outlet valve!

7. Maintenance and repair

The device does not require maintenance, but should be thoroughly cleaned at regular intervals. In the event of a fault, the device must be taken
out of use immediately. Repairs must only be carried out following prior consultation with the manufacturer and be carried out by a qualified
electrician. Only use original spare parts.

8. Technical data

Model: MilkPot 50
Type: 141450
Dimensions: Ø 455 mm, H 630 mm
Output: 2500 W
Voltage: 230 V
Protection type: IP 54
Protection class: 1
Weight: 32 kg
Thermostat temperature range:
Subject to technical modifications and amendments.

9. Accessories and spare parts

Ref.no. 141451 Heating element 2500 W
Ref.no. 141452 Thermostat
Ref.no. 141455 Seal for shim valve DN32
Ref.no. 141462 Supporting feet
Declaration of conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements and other relevant stipulations
and regulations. The CE mark confirms compliance with the Directives of the European Union. The declaration of conformity can be viewed by visiting http://www.kerbl.de.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations. The device must not be disposed of in
household waste. In accordance with the stipulations of the EU Directive on the Disposal of Electrical and Electronic Devices, the device can be disposed of free of
charge at the local waste collection or recycling centre. Alternatively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure
environmental protection and prevents any adverse effects on human health and the environment.
0 - 100°C
Ref.no. 141450 + 141462
10