Inserting / Changing Batteries - Maxx-world Z 05795 Mode D'emploi

Inserting / Changing Batteries

Remote Control
The battery in the remote control is already inserted. All
you have to do is remove the transport securing device.
1. Push the catch on the battery compartment to the right
using your fi nger nail and pull out the battery compartment.
2. Remove the used battery and dispose of it in an environ-
mentally friendly way.
3. Insert a 3 V battery of the CR2025 type. Ensure the correct
polarity (+/-) when inserting the battery.
4. Place the battery compartment back into the remote con-
trol. It must engage audibly.
LED Spotlight
You require three 1.5 volt batteries of the AAA type. The-
se are not supplied with the article!
6. Take off the battery compartment cover (e.g. with your fi n-
ger nail or a screwdriver).
7. Insert three 1.5 volt batteries of the AAA type into the bat-
tery compartment. Ensure the correct polarity (+/-) when
inserting the batteries.
8. Place the battery compartment cover back on the batte-
ry compartment and close it by turning it in the direction
17
5. The battery compartment of the
LED spotlight is located on the
back of it. Open the battery com-
partment on the back of the LED
light by turning the battery com-
partment cover in the opposite
direction to the arrow marked on
it (e.g. with your fi nger nail).
EN