Appliance Description; Interesting Facts; Before The First Use - Carmen CBS0301P Mode D'emploi

1. Display
2. Keys for setting SET
3. Glass surface
4. Measuring electrodes
5. UNIT button
6. Battery compartment
The measuring principle of the diagnostic scale
This scale determines the body weight, bodyfat, body water and the percentage of muscle according to the principle of
Bioelectric Impedance Analysis (BIA). With this process, an imperceptible, completely safe and harmless current enables the
determination of body tissue proportions within seconds. This measurement of electrical resistance (impedance) and the
inclusion of constants and/or individual values (age, height, gender) can be used to determine the percentage of fat, water
and muscle in the body. Muscle tissue and water have good electrical conductivity, as the fat cells hardly conduct the current
due to their very high resistance.
Weighing correctly
If possible, always weighs yourself at the same time of day (ideally in the morning), after going to the toilet, on an empty
stomach and without clothes to achieve comparable results. Minor deviations are normal. When you drink 1 glass of
water for example a difference of 300 grams can occur. Place the scale on a firm, flat surface; a firm floor covering is a basic
requirement for correct weight measurement.
Your scale is an accurate instrument. The human body is the hardest thing to weigh, because it is always in motion. Therefore
a 99% accuracy of the body weight is the highest possible. Stand on the scale without moving and with equal weight
distribution on both feet!
Do not underestimate the weight of clothing and when you have just eaten or drunken anything. Only the long-term trend
counts.
Before you use the appliance for the first time, please do as follows: carefully unpack the appliance and remove all the
packaging material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation. Place the scale on a firm, flat surface. Remove the batteries from
the protective packaging and insert with the correct polarity. See the diagram inside the battery compartment.
Press the UNIT button on the back of the scale to select the correct measuring unit (kg/st/lb).
kg = kilograms
lb = pounds
st = stone
Place the scale on a flat and stable surface and wait for the scale to turn itself off.
Before the first use the scale must be calibrated. This must be done every time you use the scale on a different spot or when
the batterie is replaced.
Place the scale on a flat and stable surface. With your foot press on the middle of the glass surface. The full display will show
and when it shows "0.0" the scale is ready for use.

Appliance description

5
6

Interesting facts

Before the first use

15 • EN
1 2
3
4