Setup Instructions - FreezyBoy One Black Mode D'emploi

15.4
18
18
46
Space required by FreezyBoy
with raiser
Width: 18 cm (17.0 cm plus 1 cm)
Depth: 42 cm (37.0 cm plus 5 cm)
Height: 40.5 cm
Space required by FreezyBoy
without raiser
Width: 18 cm (17.0 cm plus 1 cm)
Depth: 42 cm (37.0 cm plus 5 cm)
Height: 37.5 cm

Setup instructions

1. Remove all parts from the drawer pull-out and
clean it.
2. Extend the pull-out as far as you can.
3. Check the height of your waste bin if you are
planning to fit FreezyBoy
waste bin is higher than FreezyBoy
use the raiser supplied with your new appliance.
If using raiser: Place the raiser on the base of
4.a)
the pull-out, 9.5 cm to the right of the centre of
the front panel.
Position it so that the short end with the tab
touches the front panel. Screw in the raiser.
9.5
If not using raiser: Position the mounting
b)
plate on the base of the pull-out, 9.5 cm to the
right of the centre of the front panel. Position it
so that one of the long ends touches the front
panel. Screw in the mounting plate.
9.5
5. Place FreezyBoy
the pull-out.
®
®
beside it. If your
®
, you can
®
on the floor next to
®