Kenwood X600F Mode D'emploi page 4

Connection
WARNING
Remove the ignition key and
disconnect the negative · terminal of
the battery to prevent short circuits.
CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before
changing the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or
connectors are touching the car body. Do
not remove caps from unconnected wires or
connectors to prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car
can cause this unit to fail.
• After installation, check that the brake
lamps, winkers, and wipers work properly.
* Commercially available parts
WARNING
To prevent fire caused by a short in the
wiring, connect a fusible link or breaker
nearby the battery's positive terminal.
About the Lead Terminals
1. Wire Thicknesses
You can use wires with the following thicknesses:
Battery wire and ground wire
Speaker wire
2. Strip the wire
Make a cut in the wire sheath (insulator made from vinyl, etc.) at the
position 10-13 mm away from the end of the wire, and then remove the
unnecessary portion of the sheath by twisting it.
3. Install the wire
Loosen the screw using the supplied hexagon wrench. Insert the
conductor of the wire in the terminal hole, and then tighten the screw.

English
CENTER UNIT
(CD receiver, etc.)
Power control wire*
Hexagon Wrench
(Small)
Hexagon
Wrench (Large)
Use the
attached
Hexagon
Wrench.
Battery wire*
Protective Fuse*
Ground wire*
Battery
AWG 4 – AWG 6
AWG 8 – AWG 12
Hexagon Wrench
(Small)
BATT. GND
LEFT RIGHT
FUSE [30Ax2] P.CON BRIDGED
SPEAKER OUTPUT A
Terminal cover
LEFT RIGHT
BRIDGED
SPEAKER OUTPUT A
10 - 13 mm
(3/8" - 1/2")
RCA cable*
Use the
attached
Hexagon
Wrench.
LEFT RIGHT
L
R
BRIDGED A B A
SPEAKER OUTPUT B LINE IN LINE OUT
A channel input
B channel input
Bridged Connections
LEFT RIGHT
BRIDGED
SPEAKER OUTPUT B
Hexagon
Wrench
(Large)
NOTE
Use a RCA cable
with a straight
terminal. If a RCA
cable with L type
terminal is used, it
may not be able to
connect.
Left input
+
B
Right input
B channel
Right speaker
B channel
Left speaker
A channel
Right speaker
A channel
Left speaker
B channel
Speaker (Bridged)
A channel
Speaker (Bridged)
Hexagon Wrench
(Small)