Replacing Carbon Brushes; Optional Accessories - Makita UB1103 Manuel D'instruction

Do not use the tool for blowing air into objects, like
•
rubber rafting, balls or other inflatable products.
Increased motor revolution may cause dangerous
fan breakage.
Blowing
3
1
2
014257
For dust blowing, attach nozzle to blower outlet. Turn it
clockwise until it clicks.
Dust suction (optional accessory)
2
1
4
014258
For dust suction, fit nozzle onto suction inlet and dust
bag onto blower outlet. Turn them clockwise until it
clicks.
1
004757
After the bag fills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
1. Nozzle
2. Blower outlet
3. Pin
1. Dust bag
2. Blower outlet
3. Nozzle
4. Suction inlet
3
1. Fastener

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
1 2
014259
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended
•
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments
might present a risk of injury to persons. Only use
accessory or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Joint
•
Nozzle assembly
•
Dust bag assembly
•
Flexible hose
•
Nozzle assembly (Long size)
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
5
1. Limit mark
1
1. Brush holder cap
2. Screwdriver