Makita LC01 Manuel D'instruction page 6

1
2
010023
Now point suction inlet downwards, turn
capsule in direction of arrow in diagram, and
disconnect capsule slowly and straight.
NOTE:
Dust may spill out when capsule is
•
opened, so be sure to set a garbage
bag beneath capsule.
1
2
010024
Remove accumulated dust from inside of
capsule and off of prefilter.
1
2
010025
Twist prefilter in direction of arrow to
unfasten securing lip from cleaner unit and
then pull off prefilter.
2
010026
1. Capsule
2. Suction inlet
1. Prefilter
2. Capsule
1. Prefilter
2. Securing lip
1. Filter
2. Prefilter
1
Clean out fine dust from prefilter. Next,
remove filter, and lightly tap to dislodge dust.
Reassembly
1
010070
Put on filter until it is fully in position on the
cleaner unit.
NOTE:
Make sure filter is put on straight
•
without being peeled back. If filter is put
on incorrectly as shown in diagram,
dust will get into motor housing, and
cause motor failure.
1
010028
Connect prefilter. At this time, make sure to
twist prefilter so that securing lip is firmly
locked into cleaner unit.
2
1
010029
6
1. Filter
1. Filter
1. Prefilter
2. Securing lip