General; Carrying Handle Positions; Sun Canopy; Attaching The Maxi-Cosi Cabriofix To The Maxi-Cosi Or Quinny Frame - Maxi-Cosi CabrioFix Mode D'emploi & Garantie

5. GENERAL

5.1 Carrying handle positions

• The carrying handle can be adjusted into 3 positions.
• Press the buttons on both sides of the carrying handle at the same time and then adjust the carrying
20
handle to the desired position (20). The buttons will pop up again once the handle is in place.
1. Carrying position/driving position
2. Sleeping position/rocking position
3. Sitting position

5.2 Sun canopy

The sun canopy is located in the rim of the shell.
• Place the carrying handle in the carrying position.
• Open the rim by pushing the button at the back under the rim (21) and releasing it.
21
• The sun canopy is now visible in the opening (22).
22
• Pull it out and place the ends of the sun canopy with the buttonholes over the hooks on the carrying
23
handle (23).
• When storing the sun canopy, make sure you place it in the rim carefully and close the rim properly
24
(click) (24).
Important! The Maxi-Cosi CabrioFix is sometimes carried by the rim, therefore check that it is closed
properly.

5.3 Attaching the Maxi-Cosi CabrioFix to the Maxi-Cosi or Quinny frame

• Unfold the frame and place the Maxi-Cosi CabrioFix with the upper section in the direction of traffic on the
25
adapters of the unfolded frame until the Maxi-Cosi CabrioFix clicks into place (25).
• Check to make sure the Maxi-Cosi CabrioFix is attached securely.

5.4 Removing the Maxi-Cosi CabrioFix from the Maxi-Cosi or Quinny frame

• Place your thumbs on the control buttons on both sides of the Maxi-Cosi CabrioFix.
• Push in the buttons while lifting the Maxi-Cosi CabrioFix from the frame (26).
26
Instructions for use
GB
15