Safety Instructions Relating Specifically To The Equipment - MeisterCraft MTB 350 C Traduction Du Manuel D'utilisation Original

5452490-Tischbohrm-man 30.01.14 07:52 Seite 42
• Check the power tool for any
damages.
• Before continuing to use the power
tool, protective mechanisms and
lightly damaged parts should be
carefully examined for perfect and
proper functioning.
• Check whether parts have been
damaged. All parts must be mounted
correctly and meet all requirements in
order to ensure perfect operation of
the power tool.
• Damaged protective mechanisms and
parts must be repaired or replaced
properly by an authorised specialist
workshop if no other course of action
is specified in the operating
instructions.
• Damaged switches must be replaced
by a customer service workshop.
CAUTION! The use of other tool
inserts and other accessories
may pose a risk of injury.
6 – Safety instructions
relating specifically to
the equipment
• Never hold workpieces with your
hands. Always use clamps or a
machine vice.
• Screw the bench drill to a rigid, level
work surface by its base plate (B).
• Always use the correct drilling speed
to work.
• Before use always check that the
chuck, the worktable and the mounting
screws are properly tightened. Check
42
that the safety switch under the
transmission cover (7) is working
properly: the machine must switch off
when the cover is opened.
• Before cleaning, setting and adjusting
the drill or changing drill tools switch
off the drill and pull out the plug.
• Always work with the chip guard (4) in
place and wear protective goggles.
• Follow safety instructions for using
electrical equipment and the relevant
safety regulations.
• Never remove chips by hand.
Safety symbols
The symbols on the housing have the
following meanings:
When working with the table
drill wear goggles.
Wear ear defenders when
using the table drill.
Within the EU, this symbol
indicates that this product may
not be disposed of with the
ordinary household waste. Old devices
contain valuable recyclable materials which
should be recycled in order to ensure that
they do not affect the environment or the
health of humans as a result of
uncontrolled waste disposal. Please
dispose of old devices via a suitable
collection system or return it to the place it
was purchased for disposal. They will then
send the device for recycling.
Read these operating
instructions through
thoroughly before you start
to use the table drill.