Turntable Operation; Very Important - LENCO ClassicPhono TCD-2570 Mode D'emploi

PRESET MEMORY DAB/DAB+
1. When selected the desired station, press and hold the PRESET BUTTON (33) for 2 seconds.
2. The display show, "Preset Store 1: (Empty)". Turn the TUNING/ENTER KNOB (21) to select the desired
preset number, then press the TUNING/ENTER KNOB (21) to store the station.

TURNTABLE OPERATION

Lock Lever Stylus Cover

VERY IMPORTANT!

To prevent damages during transportation, a transit screw is located at the upper right side of the
turntable platform.
Before start playing, use a screwdriver and turn the transit screw in clockwise direction (screw going down)
completely. In case of transportation, remember to turn again this screw in counter-clockwise direction
to prevent damages.
Preparation
1. Open the Record Player Cover.
2. Release the Tonearm Clamp, and remove the stylus protector.
Listening to Records
1. Press the FUNCTION BUTTON (6) to select the TURNTABLE function.
2. Place a record on the turntable, over the central spindle. Place the EP adapter over the central
spindle when playing 17cm EP 45 RPM smaller records.
3. Set the Speed Selector (24) to 33/45 or 78 rpm according to the record.
4. Release the tonearm clamp, and remove the protective cap from the stylus.
5. Lift the Tonearm with the Tonearm Lift Lever.
6. Move the tonearm to the beginning of the record, or to the start of a particular track.
7. Gently lower the tone arm onto the record with the Tonearm Lift lever to start playing.
8. When the record is finished the tonearm will automatically stop and return automatically to the rest.
To stop manually, lift the tonearm from the record and return it to the rest.
Notes: Do not stop or turn the platter manually. Moving or jarring the turntable without securing the Tonearm
clamp could result in damage to the Tonearm. Put the protective cap on the stylus when not in use.
11
TRANSIT SCREW