Table des Matières
Publicité
Past recording function (PRE-RECORD)
If you start recording from the standby state of the past recording function, recording can be started with
the audio approx. 5 seconds before the recording operation.
To set the past recording to ON:
• Press [g STOP/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select "MIC REC MENU"
and press [q OK] to enter.
3
Press +, – to select
"PRE-RECORD" and press
[q OK] to enter.
4
Press +, – to select "ON"
and press [q OK] to enter.
(The factory setting is "OFF".)
To exit the setting screen, press [F2 (CLOSE)].
To record using the past recording function:
When recording mode is PCM, the past recording
function does not operate.
• Set the recording mode to MP3. (➜ page 20)
• Press [g STOP/RETURN] to stop the unit.
1
Press and hold [* REC] for 1 second or more.
The unit enters the past recording
standby mode.
Changes to 1 sec, 2 sec, 3 sec,
4 sec, 5 sec and stops at 5 sec.
The microphone audio data
approx. 5 seconds before recording
are always updated and the unit is
on standby.
2
Press [* REC].
The recording indicator lights, and recording is started
continuing directly after the preserved audio data.
To stop: Press [g STOP/RETURN]
*
The sound that occurs when the recording button is
pressed is also recorded. (When the built-in microphone
is used, etc.)
*
When the recording level adjustment (➜ page 22) is set
to MANUAL, the unit enters the past recording standby
and recording standby at the same time.
*
When the unit enters the standby state again after the
past recording standby screen is cancelled on the menu
or by stop operation, audio data is freshly-stored from
that point.
*
When recording is paused, the past recording function
does not operate.
*
If the recording remaining time is less than 10 seconds,
the past recording function does not operate.
ENGLISH
27
27
Publicité
Table des Matières
