Status Leds - LD Systems STINGER G3 Série Manuel D'utilisation

SUBWOFFER 100 HZ + SATELLITE
20 Hz
4
STATUS-LEDS
ON: Lights up once the system is properly connected to the power mains and switched on.
SIGNAL: Lights up as soon as an audio signal is present.
LIMIT: Lights up if the loudspeaker system is operating in the clipping range. A short flash of the LED in this instance is
not critical. To protect the system, an excessive signal level is gently turned down by the built-in limiters.
If the limiter LED lights up permanently or for longer periods, reduce the volume level. Failure to do so may result in a distorted
sound and damage to the speaker system.
PROTECT: Lights up if the system is overloaded/overheated. The amplifiers are muted automatically. Upon
reaching normal operating conditions, the device reverts to normal operating mode after a few minutes.
5
THRU LEFT RIGHT
Balanced line inputs with 3-pin male XLR sockets. The input signal (INPUT LINE) is routed without alteration to the line output THRU.
6
POWER IN
Blue power input socket for power supply to the device. A suitable power cable is included. For the device's maximum power input without
allowing for the POWER OUT load rating, please see the label under "STINGER SUB 15 / 18 AG3" only.
7
POWER ON / OFF
On / Off switch for the power supply of the device.
8
POWER OUT
White power output socket. See label on device for maximum load rating.
WHAT DOES LD SYSTEMS DynX
DSP stands for Digital Signal Processing, DynX® comprises the Limiter, EQ, Compressor and Crossover features. The digital signal process-
ing ensures maximum audio performance with maximum clarity and protects the PA system from overload.
WHAT EXACTLY DOES DynX
The Limiter function protects the speakers and prevents distortions caused by overload. A limiter attenuates the signal when the level
exceeds a value which could have a negative effect. The system can be operated in this manner with a higher overall sound pressure as
extreme peaks are automatically lowered, so that the total volume does not need to be reduced.
The Multiband EQ works in the lower frequency range, a low-pass filter prevents the transmission of high-frequency signals. The amplitude
and runtime optimisation is perfectly adapted to the full-range speakers of the Stinger G3 Series.
6
100 Hz
DSP STAND FOR?
®
DSP DO?
®
1 kHz
SATELLITE
SUBWOOFER
TOTAL
20 kHz