Description Of The Appliance - Geba Tronic Cody T4 Mode D'emploi Et Instructions De Montage

Dear customer,
The Cody which you have purchased is one of our highest quality technical pro-
ducts. We have taken the greatest care in its manufacture to ensure that this
microprocessor controlled encoder reaches you in faultless condition. However in
the unusual event of suspected equipment failure please return the appliance
together with the enclosed warranty document to your dealer or direct to our
factory.
The extent of warranty exclusively refers to the free repair of malfunctions of the
appliance, which demonstrably are caused by faults in production or defective
material, inclusive of spare parts required for this purpose.
Therefore please first read the instructions of use carefully before you start
programming !!!
Technical Data:
Supply voltage 230 V AC 50 Hz
Relay contact max 7 VA 12 V/Ac, approx. 5 sec.
Connections 2.5 mm
Ambient- -20 ˚C to +60 ˚C
temperature
Warranty-document
On the below described encoder we grant a warranty of
Type: TCS - Cody - T4
Production date: ____________________________________________________
Sales date: ____________________________________________________
Dealers adress:
industrial controls
2
max.,
2 years
®

Description of the appliance

The TCS-Cody-T4 consists of a decoder and a keypad. These units are connected by a
simple double-wire cable without a special plug. The appliance connected is controlled by
the input of a correct pass code.
Passing code:
The pass code is either a four- or five-digit numeral code, by which you operate your
electric-door-lock. You have the possibility to store up to four different pass codes, which
means that up to four different persons with different pass codes can open the door. In case
you are accompanied by another person when entering your passing code you can at
first press as many keys as you like before you finally enter your code. This ensures that
no other person can notice your pass code. Nevertheless, the TCS-Cody recognizes your
pass code as correct! The TCS-Cody is preset by the company with the pass code 1234 on
memory location 01.
Blocking function:
For reasons of safety during attempts of manipulation the TCS-Cody -T4 automatically
blocks for 10 seconds after the input of a wrong pass code which is signalled with a
double sound signal. The end of the blocking time is signalled by a long sound signal.
Programming:
The appliance is programmed with four possible pass codes. The logic unit is fitted with
DIP SWITCHES (see figure below). Those four switches correspond to the four memory
locations for the individual pass codes.
In order to input a pass code set the corresponding switch to programming position
(ON-position). At the keypad now enter the desired four- or five-digit new code and ´
actuate the key-operated push button. Then set the switch back to normal operating
position. The relay now attracts and the door can be opened.
Any previously stored code in this position is now overwritten.
This procedure can now be repeated for the other three code positions.
Connection diagram:
keypad
Switch fo
door-opener
industrial controls
Tastatur
DIP SWITCHES
DIP-Schalter
ON
1 2 3 4 Trans-
former
Trafo
N L1
2
Spannungsversorgung
power supply
230V/50Hz
3
2
2
®
door-opener
Türöffner max. 7 VA
max. 7 VA 12V/AC
12V/AC