Getting Started - TilGreen TilRoue Notice D'utilisation Originale

1 10 4
8 - 9
5
2
3
1- Grip 8- On/off button
2- Casing 9- Light switch
3- Pedal 10- Distance button (Odometer/Trip)
4- Silicone protection
11- LED screen (distance, battery..)
5- Lights (x4) 12- Inflatable tyre
6- Rear light (red) 13- Charging socket and 2 USB ports
7- Front light (white)
TilRoue specifications
Description Parameters
Maximum speed Around 20 km/h
Distance Up to 25 km
Maximum tilt angle 40 degrees
Min / max load. 50 kg / 120 kg
Dimension (H x L x l) 460 x 400 x 125 mm
Tyre Inflatable
Pedal (height / ground) 110 mm in aluminum
Weight 10.6 kg
Operating temperture - 10° C to +40° C
11
6
7
12
Comments
An alarm sounds from 16 km/h. Self-balancing function adjusts to speed.
Depending on use
The motor stops at a 40° tilt angle. Recommended tilt: 15°
Adapt tyre pressure to the user's weight
Adjustable pressure using a pump
Weight without the 2 stabilizer wheels
Recommended temperature (10 to 36° C)
Battery specifications
13
Description
Type of battery 132 Wh Lithium battery (Samsung cells)
Charging time Around 60 mins for a full charge
Voltage 36 Volts
Charging temperature -10 to 40°C
Storage humidity 5% to 95%
Before use
Charging your TilRoue
Ensure that the connection plug is dry,
•
• Insert the charging plug (100 - 240 V, 50 - 60 Hz) into the connector,
• When the battery's light is red the battery is charging,
If the charger's light remains green, check that the connector is properly connected,
•
When the light on the charger turns green, the battery is fully charged,
•
• It is important to stop charging when the battery is charged, otherwise there is a risk that the lithium battery will be
damaged,
• Full battery charging time is around 120 minutes,
To avoid damaging the battery, it is important to only use the charger which is supplied with the TilRoue.

Getting started

Before use, quickly check that the TilRoue Is working properly and that it is not damaged. Check that you have appropriate safety
gear. Find a safe place for using your TilRoue
Switch on the TilRoue
1- Position the TilRoue perpendicular to the ground,
2- Press the 'on' button down (8) and wait until the lights come on, and you hear a beep.
The TilRoue is ready to be used.
Switch on the lights
Press on the button under the grip to light the front and rear LED lights. Press on the button again and the lights flash.
Battery charge indicator
Your TilRoue Is fitted with a red LED screen on the front which provides accurate information on the battery charge. When the
battery is charged to over 85% the whole of the charge is shown. The indicators go out as the battery charge is used up.
The battery indicator stops functioning when the charge is below 6%. The battery indicator flashes and a rapid alarm is heard. The
TilRoue automatically slows down and stops. You must recharge the battery.
Speedometer
Your speed is shown on the red LED screen at the front of the TilRoue.
Parameters Comments
The speed adjusts to the battery's capacity
The charge is 90% after 50 mins
Recommended temperature (10 to 36° C)
Store in a dry place