Adjusting The Brakes; Braking | Parking - Drive DeVilbiss Healthcare DIAMOND DELUXE Mode D'emploi

EN
The front wheels are pushed into the holders with force
until they click into place (pic. 4). To disengage the wheel,
press the red button and pull the wheel out (pic. 5).
4
Now place the rollator (pic. 6) on its wheels (pic. 7) and
press down on the sides of the seat section until you can
hear and feel it click into place (pic. 8).
6
7
To adjust the height of the handles, press both clips and
move the guide tube into the desired position (pic. 9).
Hang the footrests such that they click into both pins
(pic. 10,-11).
9
12
Drive Medical GmbH & Co. KG | As per: 21.04.2021 | Errors and alterations excepted
5
8
10
11
To swivel them out of the way, release the lock as shown
in pic. 12. If you do not use the footrests, hang them
as shown in pic. 13 such that all 3 pins are clicked into
place; the footrests are then secured into position on the
rollator (pic. 14).
13

Adjusting the brakes

If braking is poor or too hard, the brake can be adjusted
either at the brake housing above (pic. 15) or using the
adjusting screw on the Bowden cable below (pic. 16) to
achieve the desired braking effect.
15
The brake is correctly adjusted when the brake lever as
well as the brake wires are free of play and the wheels
can be rotated without grinding noises when the brake
is released.

Braking | Parking

To brake when walking with the rollator, pull both brake
handles upwards with your hands (pic. 17). Always brake
slowly while applying equal pressure with both hands.
To apply the brakes/park the rollator, press both brake
handles downwards until they audibly click into place
(pic. 18)! To release the brake, pull both brake handles
upwards once again until they are released (brake han-
dles are in the middle position).
Instructions for use DIAMOND DELUXE
12
14
16