Height Adjustment Of Push Handles; Adjusting The Brakes; Braking | Parking; Sitting - Drive DeVilbiss Healthcare CRISTALLO Mode D'emploi

EN

Height adjustment of push handles

The push handles must be adjusted parallel to the direc-
tion of movement!
Maximum permissible angle between the longitudi-
nal center line of the handle and the direction of move-
ment is 0°.
4
The position of the locking lever itself can be adjusted
by simultaneously pulling and rotating it. To change the
height setting of the push handles, rotate the locking
lever counterclockwise in order to release the fixation.
Then lock the handle at the desired height, as described
above.

Adjusting the brakes

6
If braking is poor or too hard, the brake can be adjusted
either at the brake housing above (photo 6) or using the
adjusting screw on the Bowden cable below (photo 7) to
achieve the desired braking effect.
12
Drive Medical GmbH & Co. KG | As per: 15.09.2020 | Errors and alterations excepted
Insert push handles at
least to the "MAX" mark
in the frame tube (photo
3). Secure them at the de-
sired height by turning the
locking lever clockwise.
Adjust both handles to the
same height.
5
7
The brake is correctly adjusted when the brake lever as
well as the brake wires are free of play and the wheels
can be rotated without grinding noises when the brake
is released.

Braking | Parking

To brake when walking with the rollator, pull both brake
handles upwards with your hands (photo 8). Always brake
slowly while applying equal pressure with both hands.
8
To apply the brakes/park the rollator, press both brake
handles downwards until they audibly click into place
(photo 9)! To release the brake, pull both brake handles
upwards once again until they are released (brake han-
dles are in the middle position).
The braking effect can be impaired by wear and tear on
the tires. For this reason, regularly check the braking
effect.

Sitting

Place the rollator on an even and solid surface. Then ap-
ply the brakes. The rollator must be stable and may not
slip. Only sit upright; do not lean backwards (photo 10)!
Seated position permitted only as shown and against the
direction of movement (photo 11)!
10
9
11
NOT PERMITTED!
Instructions for use CRISTALLO