Dirna sun electronic Mode D'emploi page 17

Once in the menu, pressing the Menu Key will move onto the next configurable
parameter without saving any modifications of the current parameter. In order to
save the parameters, confirm by pressing the Right Key once in the rightmost
field of the current parameter. If no key is pressed within 20 seconds, the unit
will automatically exit Menu Mode without saving the modifications of the current
parameter.
Detailed below are the different configurable parameters:
1 - Configuring current time: The time can be set using the Plus and
+
Minus keys to increase or decrease the minutes and hours (the
+
selected field flashes). To save the time, go to the right with the
MENU
-
minutes flashing and press the Right Key. Doing this automatically
switches to the next configuration.
2 - Configuring auto-on time: Allows the time at which the unit will
automatically come on to be entered, provided Wake Mode is enabled
+
(the Wake Indicator will be on). Adjustment is the same as for the
+
MENU
-
current time setting. To differentiate it from the time setting, the decimal
X2
point of the second leftmost digit of the display will remain on as shown.
00.:00
3 - Configuring time remaining for auto-off: Allows the time which
should pass until the unit automatically powers off to be entered. If
+
this time is any other than 00.00, Auto-off mode will be enabled.
+
MENU
-
The maximum time is 05.59. Whilst this mode is active, the On/
X3
off indicator will continue to flash. To differentiate it from the other
settings, the decimal point of the second rightmost digit of the display
will remain on as shown 00:0.0
4 - Remote control recognition: Allows the remote control to be
configured. The unit displays show PUSH, indicating that any remote
+
MENU
control key should be pressed. The unit automatically recognises
X4
the remote control and gives out a beep when any remote control
key is pressed. If the remote control was previously enabled for
the unit, the displays will show OFF and this remote control will be
disabled. If it was not previously disabled, the displays will show
On. Pressing the Right Key will confirm the changes and move to
the next setting.
17
EN