Cleaning And Maintenance; Technical Specifications - Toolland Ddph2 Mode D'emploi

it. Note that there is still about 10° side-to-side slack. For sloped panel mounting, leave the cradle
unlatched.

Unlock the casters [3] and raise the backstop [6]. Carefully roll the lift to where the panel needs to
be installed.

For sloped or wall panel mounting, always lower the backstop [6] before lifting the panel.

Turn the winch wheel [16] until the panel is at the desired height. Always check for overhead
obstructions when lifting a panel. Note that the brake is spring-operated, preventing the panel from
automatically lowering when releasing the winch wheel.

To lower the panel, hold the winch wheel [16] and slowly release the brake handle [18].

Make sure the panel is sufficiently attached to the wall or ceiling before removing the
hoist.
7. Disassembly

To disassemble the lift, lower the cradle [20] as far as possible, and slide the extension arms all the
way in.

Remove the crossbars [21] by pushing on the flat springs and separating the tapered plates.

Unlock the tilt latch and lift the cradle about 8 cm to release it from the vertical frame.

Hook the retaining hook [15] over the telescopic parts [8], [9].

Rotate the lock [12] at the end of the slide bar [11] counter clockwise and lift the slide bar [11].

Turn the winch wheel [16] until the winch assembly [10] is tight to the vertical frame [7].

Gently pull the vertical frame [7] up while holding the tripod down.

Press and hold the ring of the yoke [4] down while folding the two outer legs [2], until the yoke pin
snaps into the locking hole near the caster.
8.

Cleaning and Maintenance


Keep the brake drum [17] clean and dry at all times. Check the drag on a regular basis to ensure
proper functioning of the hoist.

Occasionally oil the cable pulleys. To access the inner pulleys, winch the lift up as far as possible.

Occasionally oil the bearings of the casters.

When operation becomes less smooth, apply some household paraffin to the sliding surfaces.

Always store the hoist in a clean and dry area protected from harsh conditions.
9.

Technical Specifications

lift height
max. .......................................................................................... 3.35 m (11 ft)
min. ............................................................................................ 1.22 m (4 ft)
loading....................................................................................... 0.86 m (34 in)
load weight (max.) ............................................................................ 68 kg (150 lb)
load dimensions (max.) ...................................................... 4.88 x 1.22 m (16 x 4 ft)
weight ...................................................................................................... ± 48 kg
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.toolland.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 02 – 06/02/2017
DDPH2
6 ©Velleman nv