Publicité
Les langues disponibles
Les langues disponibles
6 6 . . P P r r o o t t e e c c t t i i o o n n
The LS700P has circuitry to prevent clipping, over current and over excursion. The circuitry
does not alter the frequency response as the level changes. At high levels the limiter will
limit the gain of the LS700P and hence if the user attempts to set the subwoofer level
control at high levels the resulting setting will be incorrect. The level control should be set
while operating at low levels (under 10 watts). If the level control is set to high due to setting
it at high operating levels the input circuit will clip and the dynamics of the bass will be lost.
This can happen without audible distortion since the filters will filter out the distortion.
L L S S 7 7 0 0 0 0 P P C C O O N N F F I I G G U U R R A A T T I I O O N N E E X X A A M M P P L L E E S S
LS700P
POWER
SUBWOOFER
AMPLIFIER
Output
ONE SUBWOOFER, WITH MONO SYSTEM
LS700P
POWER
SUBWOOFER
AMPLIFIER
Left
Left
Right
Right
ONE SUBWOOFER, WITH STEREO SYSTEM
Note: The LS700P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our
E160 cabinets. The support tube can be adusted up to it's full 5'4" extension safely as long as the LS700P is not
WARNING: Larger or heavier cabinets should not be used!
FULL–RANGE
SPEAKER/s
FULL–RANGE
SPEAKER
élite
L
INPUT
FULL–RANGE
SPEAKERS
ONE SUBWOOFER USING ÉLITE PROCESSOR
inclined more than 10˚ (10 degrees).
3
Left
Right
POWER
LS700P
LS700P
AMPLIFIER
SUBWOOFER
SUBWOOFER
TWO SUBWOOFERS PER SYSTEM
PROCESSOR
LS700P
R
MID/
SUB
MID/
SUB
SUBWOOFER
HI
OUT
INPUT
HI
OUT
Left
POWER
Right
AMPLIFIER
R
AMP IN
AMP OUT
L
FULL–RANGE
SPEAKER
FULL–RANGE
SPEAKERS
Publicité
