Table Des Matières - Pioneer Premier DEH-P550MP Manuel D'installation

Contents
Connecting the Units ................................ 1
When not connecting a rear speaker lead to a
-
Subwoofer
When using a Subwoofer without using the
-
optional amplifier
Installation .................................................. 7
DIN Front/Rear-mount ...................................... 7
DIN Front-mount .............................................. 7
Installation with the rubber bush
-
Removing the unit
-
DIN Rear-mount ................................................ 9
Installation using the screw holes on the side
-
of the unit
Fixing the front panel ...................................... 10
Installing the
Steering Remote Control Unit ........ 11
Installing the Unit on a
Left-Hand-Drive Car ................................ 12
1
Connecting the Units
Note:
• This unit is for vehicles with a 12-volt battery and
negative grounding. Before installing it in a recre-
ational vehicle, truck, or bus, check the battery
voltage.
• To avoid shorts in the electrical system, be sure to
disconnect the ≠ battery cable before beginning
installation.
• Refer to the owner's manual for details on con-
necting the power amp and other units, then make
connections correctly.
• Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake
and seat rails. Do not route wiring in places that
get hot, such as near the heater outlet. If the insu-
lation of the wiring melts or gets torn, there is a
danger of the wiring short-circuiting to the vehi-
cle body.
• Don't pass the yellow lead through a hole into the
engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
• Do not shorten any leads. If you do, the protec-
tion circuit may fail to work when it should.
• Never feed power to other equipment by cutting
the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of
the lead will be exceeded, causing overheating.
• When replacing fuse, be sure to use only fuse of
the rating prescribed on this unit.
• Since a unique BPTL circuit is employed, never
wire so the speaker leads are directly grounded or
the left and right ≠ speaker leads are common.