Fitting The Remote Panel; Safety Devices; Cleaning - Zanotti ZN Série Notice De Mode D'emploi Et D'entretien

6.6 Fitting the rem ote panel (optional):
Fix the back plate to the wall using the pre-drilled holes; be careful the panel is kept in a horizontal
position.
Fit the connecting cable between panel and unit making sure not to bundle it with other cables.
ATTENTI ON
Check that the unit and its devices have suffered no dam ages during transport. P ay
special attention to the com ponents secured to the electric panel door and to the
refrigerating circuit pipes. M ount the unit as show n in the draw ings; m ake sure that the
electric connections are carried out properly.
6.7

Safety devices

W ARN I NG
Above devices have been developed to safeguard the operator's safety.

6.8 Cleaning

Clean the unit carefully. Remove any dust, foreign substances and dirt possibly deposited during handling.
Use detergents and degreasers.
ATTENTI ON
Solvents are not allow ed.
mechanical safety devices
The following
1. Fixed upper and side protections for evaporator and condensing unit, secured
by locking screws.
2. External fan protections placed on the evaporating and condensing units,
secured with screws.
electrical safety devices
The following
a. Protection of fans (belonging to motors) against high power absorption;
with automatic reset.
b. High pressure switch (only for special components) to protect against excessive
pressure; with automatic reset.
are supplied:
are supplied:
23