Hkoenig KB20 Manuel D'utilisation page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
OPERATING INSTRUCTIONS :
Note: Water reservoir and pipeline should be well cleaned before use.
Step 1. Plug out, and clean the water reservoir by adding water, then take plastic plug away to drain
out the water from water reservoir.
Step 2. Reinstall the plastic plug, and add appropriate clean water. After connecting the power supply
well, press and hold "SELECT" button for 3 seconds to activate pipeline self-clean process.
After cleaning, drain out the water by taking plastic plug away.
Step 3. Open the lid and take out the ice basket to add appropriate water into water reservoir.
Note: The water poured into water reservoir should be lower than the water reservoir's MAX
position. When water volume goes beyond the max, please open the bottom water drain
plug to drain the spare water out. Then close the transparent lid.
Step 4. Select the desired ice size, the default size of machine is large one.
Note: Please select the (S) when ambient temperature is below 15°c.When the ambient
temperature is higher than 30°C, Large ice cube sizes are recommended.
Note: For the first three cycles, the ice may be small and irregular in size.
Note: When the ice collecting tray is full please remove the ice immediately, Do not allow the
ice collecting tray to overfill.
CLEANING & USE GUIDANCE :
1. Clean the inner liner, ice collecting tray, water box, ice
shovel and evaporator frequently. When cleaning, unplug
the unit and remove the ice cubes. Use a diluted solution
of water and vinegar to clean the inside and the outside
surface of the Ice maker. Do not spray Ice maker with
chemicals or diluted agents such as acids, gasoline or oil.
Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in
the built-in structure, clear of obstruction. Do not use
mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer.
3. Reuse the machine after being idled for a period of time, it
may not have enough water to pump for air retard, and the
7

Publicité

Table des Matières
loading

Table des Matières