Recording - Teac CD-RW880 Manuel Du Propriétaire

1 Load a recordable CD-R or CD-RW disc into the unit.
Press the OPEN/CLOSE button (L), place a disc on the disc
tray with the printed label side up, and then press the
OPEN/CLOSE button (L) to close the disc tray.
Make sure and "CD-R" (or "CD-RW") indicators
NO TOC
lights on the display.
2
Select the source to be recorded using the INPUT SELECT
button.
DIGITAL (OPTICAL IN)
Select this to record a source connected to the DIGITAL IN
terminal.
ANALOG (ANALOG IN)
Select this to record a source connected to the ANALOG IN
terminal.
3
If necessary, select the mode of track number
assignment using the AUTO/MANUAL button.
When the POWER button or the STANDBY/ON button is
pressed, this setting is reset to –60 dB.
See page 18 for details.
16

Recording

1 6 4
3 2 5
4 Press the RECORD button.
and J indicators on the display will light, and the unit
enters record pause mode.
< No button will work while "WAITING" is displayed. Wait a
few seconds until "WAITING" disappears from the display.
When DIGITAL is selected in step
of the digital source ("FS 44_1K", "FS 48K" or " FS 32K")
briefly appears after "WAITING".
< "DIN UNLOCK" appears when the unit cannot perceive the
digital signal. In that case, connect a digital device to the
DIGITAL IN terminal, switch it on, and wait a few seconds
until the unit enters record pause mode.
< You cannot record if "MONITOR" appears on the display. In
that case, reload a recordable disc, wait a few seconds until
and "CD-R" (or "CD-RW") indicators light on the
NO TOC
display, and press the RECORD button again.
5 If necessary, adjust the recording level using the REC
LEVEL buttons.
Play the source to be recorded and adjust the recording level
so that the loudest sound does not exceed the "OVER"
indicator on the peak level meter.
The level can be adjusted from –∞, –60 dB to +18 dB.
< Unlike analog equipment, digital audio units produce
extremely unpleasant sounds when distorted, and there is no
"headroom" after the 0 mark. When you record digitally
from a commercially-produced CD, set the digital volume to 0
dB. This will maintain all the dynamic range of the source CD
without clipping. Only boost the signal if the source is
exceptionally quiet.
When the POWER button or the OPEN/CLOSE button is
pressed, the recording level is reset to 0 dB.
2
, the sampling frequency