Function Test; Technical Data - Elektrotechnik Schabus SHT 5002 Notice D'utilisation

5.2 Function test

5.2.1 Function test S3 sensor warning
Pushing the <TEST> button simulates a water warning at the S3 input.
5.2.2 Function test level control
Touch the sensor contacts (in sequence) with a cloth soaked in water or an electrically con-
ductive metal to simulate a change in the water level.
For your safety, we recommend that you regularly check the function of
the unit!

6. TECHNICAL DATA

Operating voltage:
Power consumption:
Sensor connections:
Sensor voltage:
Sensor switching point:
Sensor cable length:
K1 relay for S1-S2 level:
K2 relay for S3 sensor:
Functional range:
Protection class:
External dimensions (HxWxD):
7. GENERAL
Elektrotechnik Schabus GmbH & Co. KG is not liable for damages and/or losses of any kind
such as individual damages or consequential damages brought about by the water detector
not issuing an alarm despite any changes in water conditions.
7.1 Cleaning and care
Avoid the effects of moisture (spray or rain water), dust as well as direct insolation on the
device. Clean the device exclusively with a dry linen cloth; in case of heavy dirt accumulation,
it may be slightly moistened. Do not use any detergents containing solvents.
7.2 Declaration of conformity
The CE mark on the device confirms that it conforms to relevant EU directives. The declaration
of conformity is available for viewing at the address below.
Elektrotechnik Schabus GmbH & Co. KG
Baierbacher Straße 150
D-83071 Stephanskirchen
All rights, technical changes, errors and misprints are reserved.
16
230 V AC (+/-10 %)/50 – 60 Hz 12 – 16 V DC/0.5 A
approximately 3 W
2x level control/2x overflow
2.5 V AC
RS<80 KOhm
up to 50 m possible
max. 5 A/230 V
(1 potential-free changeover contact)
max. 5 A/230 V
(1 potential-free changeover contact)
0 °C/+40 °C
IP 20
57x72x90 mm