Changing The Batteries - Elta BM101 Mode D'emploi

BM101 10/16/06
GB
GB

CHANGING THE BATTERIES

• Remove the protective film from the screen.
• Remove the lid from the battery compartment on the underside of the measuring unit and
insert the batteries into the battery compartment as shown. Always observe the correct
polarity + and – of the batteries. Please only use alkaline batteries!
Important note: It can be a little difficult to take out the batteries from the compartment. Please
use a hard and accessible object such as a ball point pen.
Fig. 4
WIND THE SLEEVE AROUND THE WRIST
• Wind the sleeve around the wrist
The display of the measuring unit must be on the palm side
of the wrist.
The wrist must be free.
• Tighten the sleeve around the wrist.
Do not pull forcefully on the sleeve.
Do not tighten the sleeve too much.
12:15 PM Page 18
- 18 -
Fig. 5