Makita LC1230 Manuel D'instruction page 4

4. Do not perform any operation freehand. The
workpiece must be secured firmly against the
base with a vise during all operations. Never
use your hand to secure the workpiece.
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop
before moving
settings.
7. Do not use the tool in the presence of
flammable liquids or gases.
8. Check the blade carefully for cracks or
damage before operation. Replace cracked or
damaged blade immediately.
9. Use only flanges specified for this tool.
10. Be careful not to damage the arbor, flanges
(especially the installing surface) or bolt.
Damage to these parts could result in blade
breakage.
11. Make sure that the base is properly secured so
it will not move during operation. Use the
holes in the base to fasten the saw to a stable
work platform or bench. NEVER use tool
where operator
awkward.
12. For your safety, remove the chips, small
pieces, etc. from
operation.
13. Make sure the shaft lock is released before the
switch is turned on.
14. Be sure that the blade does not contact the
base in the lowest position.
15. Hold the handle firmly. Be aware that the saw
moves up or down slightly during start-up and
stopping.
16. Make sure the blade is not contacting the
workpiece before the switch is turned on.
17. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
18. Wait until the blade attains full speed before
cutting.
19. Stop operation immediately if you notice
anything abnormal.
20. Do not attempt to lock the trigger in the "ON"
position.
21. Shut off power and wait for saw blade to stop
before moving workpiece or adjusting tool.
22. Be alert at all times, especially during
repetitive, monotonous operations. Do not be
lulled into a false sense of security. Blades are
extremely unforgiving.
23. Always use accessories recommended in this
manual. Use of improper accessories such as
abrasive wheels may cause an injury.
workpiece or changing
positioning would
the table top before
24. Do not abuse cord. Never yank cord to
disconnect it from the receptacle. Keep cord
away from heat, oil, water and sharp edges.
25. Never attempt to cut workpiece less than 14
gauge (0.08") thick except pipe or workpiece
which cannot be secured firmly with a vise.
The piece cut off may be caught by the blade,
causing dangerous scattering of chips and/or
damage to the carbide-chips. Possible serious
injury may result.
26. Unplug
servicing.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
INSTALLATION
Positioning the tool
be
When the tool is shipped from the factory, the handle is
locked in the lowered position. Release the handle from
the lowered position by lowering it slightly and removing
the chain from the hook on the handle.
1
003771
Bolt the tool with two bolts to a level and stable surface
using the bolt holes provided in the tool base. This will
help prevent tipping and possible injury.
1
003772
4
tool before changing
1. Hook
1. Bolt
1
blade or