Spellbinders PLATINUM 6 Mode D'emploi page 4

ENGLISH
Cutting Sandwich for Wafer-Thin Dies - (Stack from bottom up)
1. Platform
2. Clear Cutting Plate
3. Paper, cardstock, craft foil, etc.
4. Shaped die template with cut ridges down.
5. Clear Cutting Plate
6. Run through the Platinum 6
fig. 5 fig. 6
Cutting Sandwich for Steel Rule Dies - (Stack from bottom up)
1. Clear Cutting Plate
2. Steel Rule Die with die facing up.
3. Paper, cardstock, craft foil, etc.
4. Clear Cutting Plate
5. Run through the Platinum 6 Machine
fig. 8 fig. 9
3
Machine
™
fig. 7
fig. 10
Embossing a Cut Shape - (Stack from bottom up)
1. Platform
2. Shaped die template (cut ridges up) with cut shape inside
3. Tan Embossing Mat
4. Embossing Plate
5. Run through the Platinum 6 Machine
fig. 11 fig. 12
Embossing Sandwich for Em-bossing Fold'ers
1. Platform
2. Em-bossing Fold'er with paper inside
3a. Clear cutting plate (for single or double-sided Em-bossing Fold'ers)
or
3b. 3D Embossing Plate (for 3D Em-bossing Fold'ers
4. Run through the Platinum 6 Machine
fig. 14 fig. 15
fig. 13
- (Stack from bottom up)
™
)
™
fig. 16