TMB PICCOLO Standard P Manuel D'utilisation page 16

INSTRUCTION MANUAL
Attention: Before using the machine, read carefully this manual.
The vacuum can be used on to suck solids substances. Do not put the working tool near eyes, ears or mouth.
DO NOT SUCK INFLAMMABLE OR EXPLOSIVE SUBSTANCES !
HOW TO MAKE THE MACHINE WORKING
Pull the machine out of the box. Join the flexible hose to the spout (1).
CONNECTION OF THE MACHINE TO THE ELECTRICAL SYSTEM
Before joining the machine to the socket, check if the cordset is damaged. If the electrical data on the plate are as the ones of the
electrical system, put the plug of the machine in the socket
ATTENTION! Disconnect the vacuum cleaner always at the plug. DO NOT PULL AT THE CORDSET
UTILIZATION
The machine can be used only to suck solid substances. Press the On/Off switch, the machine is ready for work (2).
CLEANING AND REPLACEMENT OF THE FILTER FOR AIR DISCHARGE
The machine is equipped with a special filter for air discharge (3). Removing the little drawer of the machine the filter can be
cleaned by sucking or blowing it. If it is necessary to replace the filter, it can be removed from the little drawer and replaced with a
new one.
CLEANING AND REPLACEMENT OF THE CARTRIDGE FILTER
ATTENTION! Do not use the machine without the cartridge filter.
Remove the head cover pressing the switch on the handle. Remove the cartridge filter with a little effort (4). The filter can be
cleaned by blowing it or, if necessary by replacing it. Insert the cartridge filter by pressing it down. Put again the cover, and the
machine is ready for work again.
REPLACEMENT OF THE FILTER BAG
ATTENTION! Do not use the machine without the filter bag.
The machine is equipped with a filter level indicator. This warning light comes on check, when the filter bag is full (5). Remove the
head cover pressing the switch on the handle. Remove the „old" filter bag. Put the new filter bag over the spout (6).
Put again the cover, and the machine is ready for work again.
The motor is built for maintenance free operation and does not need any particular service. The carbon brushes may need to be replaced due
to normal wear and tear caused by using the vacuum cleaner over time, and they can be replaced only by our authorized service centres.
1) PROBLEM: The machine does not work. CHECK the following points:
a) Check if the plug is connected to the source of electricity;
b) Check if the switch is in the on position;
2) PROBLEM: The machine does not have enough suction. CHECK the following points:
a) The filters may be dirty. lf they are, clean or replace them, following the instructions given in this booklet;
b) The suction hose may be obstructed. lf it is, turn off the vacuum cleaner, and then remove the cause of obstruction;
c) The tank entry may be obstructed. lf it is, turn off the vacuum cleaner, and then remove the cause of obstruction.
ATTENTION! Before performing any cleaning and maintenance on the vacuum cleaner, always disconnect the plug from the source of
electricity. Make sure that the cable is not cut or damaged (if it is, apply to the nearest authorized service centre for replacement).
SUBSTITUTION CABLE
ATTENTION !
If the cable is damaged, it must be replaced by an authorized technician from the manufacturer or in any case by a
professional qualified person, to avoid any risk.
GB IRL
OPERATION
TROUBLE-SHOOTING
16