On/Off Switch - BaByliss PRO FXFS2E Mode D'emploi

tion, which can be determined by
turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into
an outlet on a circuit different
from that to which the receiver is
connected.
• Consult the dealer or an expe-
rienced radio/TV technician for
help.
Caution: Any changes or modifi-
cations not expressly approved by
Conair Corporation, the manufac-
turer of this product and the party
responsible for compliance, could
void the user's authority to ope-
rate the equipment.
FOR DIRECT PLUG-IN
OPERATION
Make sure shaver is off. Connect
charging jack into the receptacle
at the bottom of shaver and plug
the adapter into power outlet.

ON/OFF SWITCH

To operate, simply slide switch to
the ON (I) position. To stop opera-
tion, set to the OFF (O) position.
VERY IMPORTANT: Cutters must
be cleaned and oiled on a regular
basis for proper functioning. Fai-
lure to regularly clean and oil the
cutters will void the warranty.
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or
easily irritated by shaving, or
who suffer from a skin allergy,
should test one section on the
leg or arm before using the sha-
ver.
2. Remove the protective cover
and turn on the unit to start sha-
ving. Hold the shaver at a right
angle to the area that you want
to shave and run the double
shaving foil carefully along your
skin. Tip: In general, we recom-
mend that you shave against the
direction of hair growth, as this is
the best way to trim the hair. Pull
your skin tight, with your fingers
in inaccessible areas, to achieve
optimum results.
3. Switch the shaver off each time
after shaving and clean it.
4. Do not push the shaver on the
skin too hard as it could cause
irritation, make the shaver warm
and prevent a perfect shave.
5. Please note that it takes 2 to 4
weeks for your skin to adapt to a
shaver, so please do not change
shaving instruments in this pe-
riod of time.
6. If hair is longer than 1mm begin
by cutting the hair down first
with a trimmer, than use shaver
for a smooth close shave.
9